Which are the Operating cycles of a TAURUS BLULINE shear baler?
1 – Feeding
The pre-compression and feed box with swinging wings (1) driven by the internal crossed cylinders (2) allows the rapid compression of ferrous and non-ferrous scraps, heterogeneous and also cumbersome scrap, reducing it to dimensions such to pass through the mouth of the shears (3).
Due to the way it has been studied, the structure of the box allows scrap also to be loaded with small self-propelled vehicles and from both sides.
On request, a pre-load deck positioned laterally to the box, (4) can be supplied to de-crease loading times and increase production of the shear-baler.
2 – Operating cycle
When the first compression has been performed, which reduces the scrap to a long pack, with wings closed, the feed piston intervenes which, as well as making the scrap pack advance by the pre-determined length, further com-presses the material longitudinally, thus increasing its density. There-fore the material, pushed by the feed cylinder, is positioned under the shear knives to be cut. (5)
The machines with baler at the mouth of the shears have the ad-
vantage of further compressing the material to be cut vertically before being sheared. (6)
Furthermore, the presence of the clamp allows the reduction of the mobile knife work stroke and therefore the acceleration of the cutting times with consequent saving of energy and increase of production.
3 – Automatic a repetitive cycle
(with or without the intervention of the baler)
By pressing the “AUTOMATIC” button: the feed cylinder pushes the material already pre-compressed, under the shears by the pre-determined length.
When requested, the vertical clamp descends, then the guillotine makes its cut, after which the baler and the mobile blade-holder return to the start position and the cycle resumes automatically.
Option 1
A particular device allows the increase in production of the shear-baler, limiting the stroke of the mobile blade-holder at each cycle depending on the height of the material to be cut; this is all automatic and without operator intervention.
Option 2
A particular program is envisioned to eliminate the idle shearing cycles, through which the automatic shearing cycle starts only when the scrap is underneath the shears.
Manual
execution of individual movements.
The post Description of the “TAURUS” Shear-Baler operating cycle in tree steps appeared first on C. E G. Group.
source http://ceg-balersshears.com/en/description-taurus-shear-baler-operating-cycle-tree-steps/
No comments:
Post a Comment